A Guide on What You Need to Know about the 2 Shot Overmolding Process
The process of injecting any substance into the substrate that had already been injection molding is known as overmolding. The method is considered to be quite useful in a number of production processes especially with electronics. The advantage of using this method is that it is going to help you to get electronics that have superior abrasion and in addition to that, higher levels of chemical resistance. It is also going to help you with biocompatibility and quite a number of other advantages. The whole process is usually done in three stages whereby, you’re going to have a process of preparation for the whole procedure and, the conduction of the molding process and after that, checking of the results. For the method to be used, there is a combination of both low-pressure molding and in addition to that, the conventional injection molding which is very popular. The process which begins is low-pressure molding whereby, you are able to get a molded device and after that, high pressure injection molding is usually used to complete the process. You will be able to get better results through an outer layer that is going to be done through the high-pressure injection molding.
There are many industries today that usually benefit a lot from the use of this method for example, quite a number of the medical and consumer electronic applications are made through the application of this method. It is important for you to understand that all of these processes usually have been properly checked when you work with the right companies. When you work with the right company, they are going to help you with the analysis process to ensure that everything has been confirmed especially to ensure that the location has been checked and in addition to that, to ensure that you have been able to deal with all the trapped air and other issues that can cause a lot of problems. In addition to that, the analysis process is also very important for helping the company to check on the heat and pressure distribution especially because these are going to help you to gauge the overmolding process. In addition to that, they also ensure that there has been proper understanding of how the injection molding process is supposed to be done and in addition to that, how these electronics can be properly cited.
The overmolding of electronics is going to be done through the right materials and that’s another advantage of working with the right people. The reason why this is very important is simply because it is going to help you to get materials that are going to help you to achieve good adhesion levels. It is good for you to work with the right experts if you are going to do overmolding.